Filling in of gypsum plasterboard joints, cracks in concrete, plastered and other mineral surfaces, and smoothing larger rough areas. Highly durable and elastic, well-adhering to the substrate. Not recommended for continuous puttying.
For finishing plasterboard joints, filling cracks in concrete, plaster and other mineral surfaces and finishing corners.
~0,3 kg per linear metre of joint. Maximum thickness of one layer – 10 mm.
Purpose: for interior use, dry areas
Binder: acrylic copolymer
Filler: quartz sand, special 3-component filler
Solvent: water
Color: grey
Density: 1,77-1,79 g/cm³
Particle size: <0,100 mm
pH: 8,0-9,0
Quality standards and certificates: CE marking EN 13963
VOC and SVOC: <9,0 g/l and <4,0 g/l EN ISO 11890-2
Formaldehyde concentration in filler: VdL-RL 03: 2 ppm or (1,6×10-4)%
Non–volatile–matter content: 81,0-82,0 % EN ISO 3251
Reaction to fire: C-s2,d0 EN 13501-1
The value of the load at which the first crack appears: 79,1 N
Work tools: spatula
Tool cleaning: with water
Application conditions: +10 ⁰C to +25 ⁰C and 35–80 % relative humidity
Coating thickness: 10 mm
Coverage rate: ~0,3 kg per linear metre of joint
Drying time (23 °C, 50 % RH): 1 mm dries in 3-4 hours and gains full strength in 28 days. Drying time depends on surface, layer thickness, air temperature and humidity, etc.
Surface preparation
The surface must be dry, capable of withstanding loads, stable and clean, primed with IGIS AG. Carefully prime the cracks.
Plasterboard joints finishing
Stir well before use. Fill the joint of the plasterboards with IGIS T and if it is HRAK type or deep joint let it dry. Apply the second layer with reinforcement tape 4-5 cm wider than the previous one. Avoid excess filler, form a layer up to the surface to be plastered. When layers of the filler dry well, apply a fully covering layer of the selected IGIS filler.
Precautionary statements: keep out of reach of children, avoid release to the environment, wear protective gloves/ protective clothing/eye protective/face protective. IF ON SKIN: wash with plenty of soap and water. IF IN EYES: rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
Additional hazard information: EUH208 – contains a mixture of 5-chlor-2-metil-2H-izotiazol-3-one and 2-metil-2H-izotiazol -3-one (3:1), 1,2-benzisothiazol-3(2H) -one, can cause allergy in humans.
Waste management
Do not pour into drains, water or soil. Empty, dry product package should be recycled or disposed of in accordance with national law.
Shelf life in tightly closed original packaging: 1 year from the date of manufacture
Storage and transportation conditions: store the product tightly closed in dry well-ventilated place at a temperature of +5 ⁰C to +30 ⁰C, protect against from damage, frost and direct sunlight.
Packing: 1,5 kg, 5 kg, 18 kg buckets
